S60 L5-2.4L VIN 64 B5244S6 (2003)
Hook the manifold into position. Loosely install 2 nuts.
Install the rubber mounting on the exhaust system.
Install the front SIPS bracket.
Install:
-
the remaining nuts for the exhaust manifold. Tighten
-
the upper heat deflector plate
-
the front wiring for the heated oxygen sensor (HO2S) using clips and clamps. Connect the wiring
-
the preheating hose between the heat deflector plate and the air cleaner (ACL)
-
the ground strip between the cylinder head and the firewall
-
the engine stabilizer brace between the suspension turrets.
Finishing
Install:
-
the splash guard under the engine
-
the nuts for the cover in the right-hand fender liner
-
the right front wheel Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair
-
the battery negative lead. Also read Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery,
Disconnecting.
Check
Replace the oil and oil filter.
Check:
-
the engine oil level
-
the servo oil level
-
the coolant level.
Warm up the engine until the thermostat opens.
Check the engine for leaks.
Top up the coolant if necessary.