S60 L5-2.4L VIN 64 B5244S6 (2003)
Lift up the rear edge of the sub-frame slightly using a mobile jack and universal fixture 999 5972 FIXTURE See: Tools and Equipment/999 5972
Fixture.
Locate the steering shaft joint on the steering gear.
Install a new steering shaft screw. Tighten to 20 Nm.
Install the rear engine mounting screw.
Align the steering gear so that it is positioned straight relative to the sub-frame. Tighten the screw. Tighten to 50 Nm.
Installing the sub-frame at the rear edge
-
Lift the sub-frame. At the same time locate the steering gear mounting screws in the frame and, on right-hand drive cars, the collision protection
system screw
-
Loosely install the sub-frame brackets together with the washers
-
Install the rear screws in the sub-frame. Use new screws. Do not tighten yet
-
Move the mobile jack to the front edge of the subframe.
-
Replace the front sub-frame screws
-
First tighten the screws on the left side of the sub-frame. Tighten to 105 Nm. Angle tighten 120°.
-
Then tighten the right-hand side to the same values as the left side
-
Finally tighten the screws for the brackets on both sides. Tighten to 50 Nm.