S60 L5-2.4L VIN 64 B5244S6 (2003)
Use a brass drift.
Note! Only tap the inner ring. Take care not to damage the ball holder or outer ring.
For cleaning / assembly and greasing the outer joint, see below
Note! The joint can be cleaned when assembled and blown clean before greasing. See Lubricate the constant velocity joint thoroughly. For
disassembly and inspection, see ball holder and inner ring , Remove the ball bearings, Remove the ball bearing holder and the inner ring from
the shaft, Wash the constant velocity joint components thoroughly and Install the inner ring in the ball holder. For greasing see Lubricate the
constant velocity joint thoroughly. To install the boot and joint, see Replace the snap ring, Install the new boot / boots on the drive shaft,
Apply grease in the boot and Vent the boot.
Replacing the inner boot: Remove the clamps from the inner boot
Cut the boot and remove it from the shaft.
Note! The inner constant velocity joint can be cleaned while assembled and blown clean. For greasing see Lubricate the constant velocity joint
thoroughly. Install the boot on the shaft. Carry out Apply grease in the boot, Vent the boot.
Only drive shafts with vibration damper:
Measure and note the vibration damper location on the shaft.