S60 L5-2.4L VIN 64 B5244S6 (2003)
Note! When replacing the inner boot on a left drive shaft with the vibration damper installed (only applies to cars with automatic
transmissions), the damper must be removed and installed. See Brush the drive shaft thoroughly with soapy water, Position the shaft in a vice.
Brush the drive shaft thoroughly with soapy water
Position the drive shaft on a support in a workshop press. Carefully press out the vibration damper from the drive shaft.
Clean the assembled constant velocity joint and blow clean. Grease the joint See Lubricate the constant velocity joint thoroughly
Install the boot on the shaft. Carry out operations Apply grease in the boot and Vent the boot
Position the shaft in a vice
Ensure that the shaft is absolutely free of grease. Brush the shaft and the hole in the vibration damper with soapy water.
Use drift 999 2412 PUNCH See: Tools and Equipment/999 2412 Punch. Tap the vibration damper on. Dry the soapy water off the shaft. Adjust the
damper to the measurement noted previously.
Cleaning / checking the outer constant velocity joint
Mark the outer constant velocity joint outer ring, ball holder and inner ring
Mark components in relation to each other.
Use an electric scriber.