S60 L5-2.4L VIN 64 B5244S6 (2003)
Locate the markings to each other. Install a ball bearing.
Note! Ball location.
Turn the inner ring and the ball bearing holder.
Install the balls one by one in the same positions as before. See Remove the ball bearings.
Lubricate the constant velocity joint thoroughly
Apply grease behind the joint via the shaft hole in the inner ring.
Use half of the grease packet. The remainder will be used later in the gaiter. See Apply grease in the boot.
Replace the snap ring
Install the new snap ring included in the boot kit.
Reassembly
Install the new boot / boots on the drive shaft