S60 L5-2.4L VIN 64 B5244S6 (2003)
Install the constant velocity joint on the drive shaft
Ensure that inner ring is straight in the constant velocity joint.
Tap on the constant velocity joint. Use a rubber mallet.
Check that the lock ring is seated in its groove. Do this by measuring the distance. See Check the measurement.
Apply grease in the boot
Apply the remaining grease from Lubricate the constant velocity joint thoroughly.
Note! Ensure that there is no grease on the mating surfaces between the boot and the constant velocity joint and the shaft.
Remove excess grease. Use methylated spirit.
Ensure that the boot is in position on the constant velocity joint housing.
Install a new clamp. Use pliers 951 2619 Pliers See: Tools and Equipment/951 2619 Pliers.
Vent the boot
Venting is carried out to remove any over pressure in the boot. Use a rounded screwdriver.
Carefully insert the screwdriver between the drive shaft and boot. Ensure that the boot is in position on the drive shaft.
Ensure that the boot is aligned against the inner rib on the drive shaft.
Install a new clamp. Use pliers 951 2619 Pliers See: Tools and Equipment/951 2619 Pliers.