V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Place the complete unit to one side.
-
Lock the steering wheel in the lowest, rearmost position
-
Remove the rubber seal from the upper steering wheel cover by carefully prying the 5catches loose using a weatherstrip tool.
-
Pry out the two clips (2) in the bottom edge of the combined instrument panel. Carefully remove the combined instrument panel surround
-
Then pull the surround back until the three clips (1) at the top release.
NOTE: Do not damage the dashboard.
-
Remove the four screws around the combined instrument panel
-
Pull out the combined instrument panel. Disconnect the connector on the reverse of the combined instrument panel
-
Place the combined instrument panel to one side.
Installing the bracket for the handset holder
-
Remove the screw (1) securing the semi circular section of the dashboard above the combined instrument panel
-
Take the handset holder and bracket (2) from the kit
-
Position the bracket with the wiring routed on the reverse of the bracket
-
Tighten the bracket to the handset holder using the screw (1) for the semi circular section
-
Route the wiring down into the hole behind the dashboard.
-
Press the bracket against the mating surfaces where the three holes are to be drilled
-
Hold the bracket firmly in place. Drill the two marked holes through the bracket and the dashboard. Use a 5 mm (13/64 inch) diameter drill bit.
Use a 25 mm (1 inch) diameter drill stop.