V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Illustration A
-
Take the iPod adapter power supply cable, P/N 30660444, from the kit.
-
Remove the two left screws in the tailgate sill trim panel.
-
Pull up the sill panel at the rear end of the load floor support and insert the ground cable in the space for the foam rubber seal.
-
Tighten the two screws.
-
Connect the ground cable (1) to the existing grounding point behind the battery and tighten to 10 Nm (7 lbf.ft.).
Illustration B
-
Position the red/white (R/W) wires and the green connectors at the rear edge of the wheel housing.
-
Route the cable end (2) with the blue connector on the top of the wheel housing along existing cables and then down along the right side of the
wheel housing. The route it beneath the foam rubber on the bumper mounting, under the insulating mat and up to the iPod adapter. Make sure that
the cable does not chafe against the edges.
-
Clamp in the cable at the existing cable harnesses using three tie straps from the kit.
Connection to the rear fuse holder, for cars without RTI
-
Position the cables with the two green connectors back along the cable and fasten them with foam tape.
