V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Install the new insulation panel (from the kit).
-
Reinstall the fuse holder.
-
Remove the four screws in the tailgate sill panel.
-
Position the short single cable along the tailgate sill trim panel.
NOTE: The cable end with the plastic connector must be on the left-hand side.
-
Pull up the plastic connector to the control module
-
Route the other end of the cable in front of the righthand tail lamp to the aerial amplifier
-
Carefully pull the tailgate sill trim panel upwards by the outer edges on the right and left-hand sides until a click is heard and the clips release
-
Lift the panel and insert the cable harness (1) in the gap between the floor support (2) and the panel
-
Insert the cable as far under the panel as possible. Ensure that the cable is not trapped
-
Press the panel into place
-
Reinstall the screws in the panel. Tighten.
-
Take the aerial amplifier (1) from the kit. Connect the cable (2) to the connector (3) for the aerial in the rear bumper by the right-hand tail lamp
-
Position the aerial amplifier on the edge of the panel in front of the right tail lamp as illustrated
-
Tighten the aerial amplifier.