V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Oil the new seal.
Install the new seal for the exhaust camshaft. Use drift 999 5719 Drift See: Tools and Equipment/999 5719 Drift.
Install the new seal for the intake camshaft. Use drift 999 5718 Drift See: Tools and Equipment/999 5718 Drift.
Remove the engine cooling fan (FC)
Remove:
-
slacken off the brake vacuum hose from the intake
-
the air cleaner (ACL) housing intake pipe from the connection above the radiator. Twist the pipe up
-
the manifold absolute pressure (MAP) sensor from the front cover plate
-
the evaporative emission system (EVAP) valve from the engine cooling fan (FC) shroud
-
release the wiring from the fan shroud.
Lift out the hose for the expansion tank from the holders on top of the fan shroud.
Disconnect both the engine cooling fan (FC) connectors.
-
both screws holding the fan shroud.
Carefully lift up the engine cooling fan (FC).
Install radiator protection 999 5474 RADIATOR PROTECTION See: Tools and Equipment/999 5474 Radiator Protection.
Installation
Checking and adjusting the variable valve timing unit
Check and adjust the variable valve timing unit. See: Variable valve timing unit, checking and adjusting See: Testing and Inspection
Reinstall
