V70 2.4 L5-2.4L VIN 61 B5244S (2001)
-
Separate the fuel line quick-release connector. Use tool 951 2666.
-
Remove the mounting screws from the fuel rail.
-
Spray universal oil or similar around the injector nozzle at the terminal on the intake manifold.
-
Gently work the fuel rail and injector nozzles loose.
Remove (only when replacing the intake manifold)
-
all 5 vacuum hoses from the intake manifolds. (See the above figure)
NOTE: Ensure that the plastic nipple (5) located in the terminal at the intake does not follow the hose.
-
Remove
-
the screw holding the dip stick pipe to the intake manifold
-
the screw at the support bracket (under the intake manifold).
Disconnect the connector for the throttle body (TB)
-
the mounting screws in the upper row and the outer screws in the lower row
-
the intake manifold, by lifting it approximately 20 mm.
Allow the crankcase ventilation hose to run through the intake manifold without disconnecting it from the flame trap.