V70 2.4 L5-2.4L VIN 61 B5244S (2001)
Transferring components when replacing the intake manifold
-
Transfer the electronic throttle module.
Use a new gasket.
Tighten to 10 Nm.
Installing the intake manifold and gasket
NOTE: Ensure that the gasket faces are clean.
Install
-
a new gasket held in position by the lower screws for the intake manifold
-
the intake manifold
-
the crankcase ventilation. The crankcase ventilation must be installed through the gap between the second and third channels
-
the three upper screws. Tighten all screws (starting from the center) to 20 Nm
-
the screw at the support bracket (under the intake manifold).
Finishing
Install
-
the fuel rail and the injector nozzles.
Use new screws. Tighten to 10 Nm. Press the quick-release connector together until a clicking sound is heard.
-
the connectors for the injectors and the cover plate
-
the crankcase ventilation hose on the top of the cam cover. Use a new clamp
-
the vacuum hoses.
Ensure that the plastic nipple, located in the terminal at the intake for the crankcase ventilation hose, is in the correct position
-
the inlet hose between the air cleaner (ACL) and throttle body (TB)
-
the hose for vacuum controlled crankcase ventilation in the inlet hose
-
the cover over the ignition coils
-
the connectors to the throttle body (TB)
-
the dip stick in the intake manifold.
Install the battery negative lead.
Final check
Test drive the car. Check the following: