Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Brakes and Traction Control > Hydraulic System, Brakes > Brake Master Cylinder > Component Information > Service and Repair > Replacing and Cleaning Brake Fluid Reservoir > Page 5670
Brake Master Cylinder: Service and Repair
Replacing the master cylinder
Clean around brake fluid reservoir cap, by pipe connections, and, if necessary, by hose connection between reservoir and master cylinder to prevent
Release non-return valve in air hydraulic brake power assist unit (brake servo) or pump brake pedal until it goes hard to avoid
Put rags under master cylinder to prevent brake fluid spillage on paintwork surfaces.
Do not open the master cylinder under any circumstances. It takes special equipment and facilities to reassemble.
Removing master cylinder
Brake fluid reservoir as per (Not for VADIS use) Brake fluid reservoir, replacement and cleaning Brake fluid reservoir, replacement and
Connector to EBD sensor from master cylinder.
Brake pipe from master cylinder.
Plug brake pipe to prevent dirt entering braking system.
Installation, master cylinder
That there is no dirt in the master cylinder connections and that the packing box is intact.
|[PREV PAGE] [NEXT PAGE]|