Volvo Workshop Manuals
V70 XC AWD L5-2.4L Turbo VIN 56 B5254T (1998)
Powertrain Management > PROM - Programmable Read Only Memory > Component Information > Technical Service Bulletins > Campaign - Transmission Control Module Software Upgrade > Page 4459
Place the new on top of the old label.
Do not cover the Bosch Part Number.
On the new label write the part number listed on the PC-screen, your dealer code, and the programming date.
When the ECM is successfully programmed, the LapTop PC screen will display the message "ECM Successfully Programmed".
Switch oft the programmer
Disconnect the ECM from the Programmer
Install Engine Control Module (ECM) in vehicle
Inspect connector pins sockets for damage
Reinstall engine control module (ECM).
Reinstall fuse no. 1.
Switch on ignition.
Read off any diagnostic trouble codes (DTCs).
Erase diagnostic trouble codes (DTCs) and reset adaptive functions.
It is important that both diagnostic trouble codes (DTCs) are erased and adaptive functions are reset when the engine control module (ECM) is
|[PREV PAGE] [NEXT PAGE]|