volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 12
background image

-

First tighten the screws crosswise. Tighten to 8 Nm. Then re-tighten crosswise. Tighten to 30 Nm. Use counterhold 999 5743 . 

Note! Wrong counterhold illustrated. 

-

Start tightening with the same screw both times.

-

Check that the bevel gear and propeller shaft flange mating surfaces are clean. 

-

Use new screws. 

Transmission and Drivetrain > Drive/Propeller Shafts, Bearings and Joints > Drive/Propeller Shaft > Component Information > Service and Repair > Installing Propellar Shaft, All-Wheel Drive (AWD) > Page 5087

< PREV PAGE NEXT PAGE >