V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)
Fig. 28 Front Seat Removal
Install front seat
First make sure that the SIPS bag on the new front seat has been locked with the transport safety device attached to the sensor unit.
-
Install the seat in the opposite order of removal.
NOTE: The outside rear attachment bolt (C) should be tightened last, otherwise the seat could be installed at an angle.
Tightening torques:
-
Seat/floor: 40 Nm (30 ft.lb.)
-
Belt: 20 Nm (15 ft.lb.)
When front seat is in place Do not forget to unlock SIPS bag!
-
Remove transport safety device from sensor unit.
-
Place transport safety device in holder inside seat pocket.
-
Replace seat pocket.