Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V70R AWD L5-2.3L Turbo VIN 52 B5234T6 (1998)

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Support - Half Shaft/Short Shaft > Component Information > Service and Repair > Page 5070

Page 4
background image

10. Dismantling universal joint

-

Mark driveshaft position relative to joint casing.

-

Turn back collar of joint casing tab.

NOTE:  Turn back properly so spider and needle bearings come well clear of joint casing.

-

Remove shaft from joint casing.

-

Remove needle bearings from spider.

Mark position relative to spider.

11. Clean joint casing thoroughly

Do not dismantle needle bearings.
Clean off thoroughly with a clean lint-free cloth.
Replacing support bearings, see 018-019.
Replacing boot (gaiter) and outboard driveshaft, see Constant Velocity Joint Boot, Replacement steps 12 through 18. See: Constant Velocity Joint
Boot

12. Only if replacing boot (gaiter):

Remove spider from shaft.
-

Mark spider relative to driveshaft markings. Remove circlip.

-

Push spider off shaft.

Non-turbo models:
Use drift tool 999 5118 and drift tool 999 5318, or equivalents, as support under spider.
Turbo models:
Use drift tool 999 5118, or equivalent, and put copper or aluminium plates under spider pins to prevent damage to surfaces.
-

Remove boot (gaiter) from shaft.

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Axle Shaft Assembly > Support - Half Shaft/Short Shaft > Component Information > Service and Repair > Page 5070

[PREV PAGE] [NEXT PAGE]