Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


V90 L6-2.9L VIN 96 B6304S (1998)

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Technical Service Bulletins > Page 1197

Page 6
background image

-

Tighten pipe connections to transmission 

-

Reconnect transmission connectors and oxygen sensor lead.

20. Reconnect propeller shaft 

-

Use 15 mm socket tool No. 999 5244, or equivalent. 

-

Reassemble and tighten front coupling as per markings.

21. Install air preheater pipe 

-

Lubricate O-ring with Vaseline.

22. Install front section of exhaust pipe

-

Tighten to:

10 mm 60 Nm (44 ft. lbs.) 
8 mm 40 Nm (30 ft. lbs.) 

NOTE: 
-

Undo bolted joint after catalytic converter and retighten to 25 Nm (18 ft. lbs.) 

-

This is necessary to prevent stresses in the system.

23. Check operation 

Engine, Cooling and Exhaust > Engine > Seals and Gaskets, Engine > Crankshaft Main Bearing Seal > Component Information > Technical Service Bulletins > Page 1197

[PREV PAGE] [NEXT PAGE]