XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Take the corner clip and tie strap from the wiring kit. Press it into place at the top of the underside of the bracket as illustrated
-
Tighten the tie strap around the foam taped cable harness to secure the excess fibre optic wiring as illustrated
-
Take the remaining strips of foam tape and tape the loop to prevent it from rattling.
Finishing work
-
Connect all the previously disconnected connectors to the control module and the climate control panel if not already done. If the car has a CD
player/changer, connect its connector.
Note! Be very careful when connecting the connector in the CD player/changer. The terminal pins in this connector are thin. They are
easily damaged and may become pressed into the player if the connector is not installed straight.
-
Position the bracket. Tighten the bracket using the two screws
-
Reinstall the gear selector lever panel
-
Reinstall the panel above the accelerator pedal if removed.
-
Turn the ignition key to position II
-
Reconnect the battery negative lead
-
Program the software according to the service information in VIDA.