XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Liftgate Window Glass: Service and Repair
Tailgate Windshield, Replacing
Tailgate windshield, replacing
Special tools:
951 2337 Spike See: Tools and Equipment/951 2337 Spike
951 2925 Rollout 2000 See: Tools and Equipment/951 2925 Rollout 2000
The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Removing the rear windshield
Remove:
-
the stop lamp
-
the panels. See Panel, tailgate, replacing
-
the tailgate wiper. See Tailgate wiper arm / blade, replacing See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Tailgate Wiper
Arm/Blade, Replacing.
Disconnect the heating cables for the rear windshield.
Insert a wire inserter in the upper left-hand corner as illustrated.
Cut off approximately four meters of wire from the roll.
Secure the wire and pull the ends approximately 50 cm into the car.
Pull the wire around and downwards so it forms an eyelet around the outside of the windshield.
Check that the wire is at the bottom against the bead of adhesive.
Stretch the wire so it is still in position at the bottom. Pull in the excess from one end of the wire.
