XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
the carbon filter container
-
the M6 screws for the carbon filter container.
Installing the upper control arm
Install:
-
the screws for the rear control arm mounting. Only tighten a few turns
-
the front upper control arm mounting using an M12 screw.
Installing the wheel spindle
Install the screw on the outer control arm mounting in the wheel spindle. Only tighten a few turns.
Lifting the sub-frame
Lift up the sub-frame approximately 100 mm from the upper position.
Install:
-
the clamp for the pressure pump hose
-
the pressure pump on the bracket
-
the plastic clips.
Raise the sub-frame to the upper position.
Install:
-
the bracket for the fuel filter using an M6 screw
-
the bracket for the brake pipes using an M6 screw
-
the M6 screws for the bracket for the sub-frame front mounting
-
the 4 M12 screws for the sub-frame.
For tightening torques, see Specifications See: Specifications/Mechanical Specifications/Steering.
Installing the spring
Install:
-
the lower control arm
-
the screw for the lower control arm on the sub-frame. Finger tighten