XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Applies to cars with RTI keypad mounted to the steering wheel when installing in a wooden steering wheel
-
Install the screws and attach the keypad with the clamp around the steering wheel spoke.
Applies to cars with RTI keypad mounted to the steering wheel
-
Position the horn ring as illustrated.
-
Plug in the keypad connector to the terminal on the reverse side of the keypad located on the right-hand side of the horn ring. The wire from the
installed keypad is very short and it can be difficult to install the connector.
-
Reinstall the horn ring in the steering wheel. Make sure that the three springs on the underside are correctly positioned. Check that the ground lead
is not trapped.
-
Install the three screws in the horn ring and tighten crosswise them to 8 ± 2 Nm (6 ± 1.5 lbf.ft.).
Note! The screws are self-tapping.
-
Reinstall the ground lead. Tighten.
Note! Make sure the screw is properly tightened and that the ground lead is secure. The screw is self-tapping, which can make it difficult
to tighten.
-
Check the function of the horn by pressing the horn around its entire circumference. A metallic noise should be heard when the three contact points
come into contact
