XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Lock the nut with the lock washer.
Adjusting gear-shift position sensor
Adjust the gear-shift position sensor. See Gear-shift position sensor, checking/adjusting See: Sensors and Switches - A/T/Transmission Position
Switch/Sensor/Adjustments.
Installing the gear-shift position sensor, continued
Install:
-
the lever on the gear shift linkage rod. Tighten. See
-
the gear selector cable and bracket on the transmission using 2 M8 screws. Tighten
-
the ball joint for the gear selector cable on the lever. Press into place by hand.
Installing engine compartment components
Install the air cleaner (ACL) housing, including all hoses and electrical terminals.
Checking diagnostic trouble codes (DTCs)
Check and erase any diagnostic trouble codes (DTCs).
Sealing Ring Oil Pump, Replacing
Sealing ring oil pump, replacing
Special tools:
999 5069 Extractor See: Tools and Equipment/999 5069 Extractor
999 5117 Punch See: Tools and Equipment/999 5117 Punch
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.
Removal
