XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Lubricate the torque converter throat with ATF oil.
Note! Take care not to damage the oil pump during installation.
Make sure torque converter is as far into the transmission as possible. Check with a ruler. The distance between the cover and retaining tabs must be
approximately 14 mm.
Installing the transmission
FWD
-
for gasoline engines, see Transmission, installing See: Service and Repair/Removal and Replacement.
AWD
-
for gasoline engines, see See: Service and Repair/Removal and Replacement
Connecting Sleeve
Connecting sleeve
Note! Some variation in the illustrations may occur, but the essential information is always correct.
Removal and Installation
Remove and install connecting sleeve. Refer to: Sealing ring connecting socket drive shaft/differential, replacing See: Drive Axles, Bearings and
Joints/Seals and Gaskets/Service and Repair/Sealing Ring Connecting Socket Drive Shaft/Differential, Replacing
Sealing Ring, Crown Wheel Shaft, Left-Hand Side, Replace
Sealing ring, crown wheel shaft, left-hand side, replace
Special tools:
999 7086 Puller See: Tools and Equipment/999 7086 Puller
999 7087 Drift See: Tools and Equipment/999 7087 Drift
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information is always correct.
Preparatory work
Removing bevel gear
Remove the bevel gear. See
Removal
Removing the sealing ring