XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Install the new sealing ring for the drive shaft.
Lubricate the seal using wheel bearing grease, P/N 116 1241-3.
Use drift 999 5654 Punch See: Tools and Equipment/999 5654 Punch. Tap in sealing ring to its stop.
If also replacing the seal for the crown wheel shaft, proceed to replacing.
Note! To install the drive shaft, see Replacing the front right drive shaft See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and
Repair/Drive Shaft Right, Replacing.
Sealing ring for crown wheel shaft for bevel gear, replacing
Marking the position of the adjustment nut
Mark the position of the adjustment nut in relation to the housing with a scriber.
Measure the height between the nut and housing. Make a note of the measurement.
Remove screw and split pin.
Removing the adjustment nut
Remove the adjustment nut.
Use wrench 999 5371 NUTS-DIFF.BEARING) 1035 See: Tools and Equipment/999 5371 Nuts-Diff. Bearing 1035.
Removing the sealing ring