Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Pulse Wheel Drive Shaft, Replacing > Page 2947

Page 4
background image

-

the wheel sensor (10 Nm)

-

the wheel sensor wiring in the clip on the brake hose and on the tank.

Secure the new connector to the loose cable/wire.
Pull up the sensor connector between the fuel tank and the body.
Disconnect the cable / wire from the connector.
Install the cover over the level sensor. Tighten the nuts.
Connect the wiring and the connectors.

Applies only when replacing the left-hand sensor

Remove the block from under the seat frame.

Install:

-

the 8 seat frame screws. Tighten to 50 Nm

-

the 2 seat frame screws. Tighten to 24 Nm.

Finishing

Fold the carpet down.

Install:

-

the center rear seat. See Upholstery backrest cushion center (second row), replacing See: Body and Frame/Seats/Seat Cover/Service and
Repair/Rear Seat, Passenger Seat, Seat/Upholstery Backrest Cushion Center (Second Row), Replacing 

-

the outer rear seat. See Upholstery backrest cushion outer (second row) See: Body and Frame/Seats/Seat Cover/Service and Repair/Rear Seat,
Passenger Seat, Seat/Upholstery Backrest Cushion Outer (Second Row).

Install the wheels. See Installing wheels See: Maintenance/Wheels and Tires/Wheels/Service and Repair.

Function test

Check the function. See Wheel sensor front, replacing See: Wheel Sensor Front, Replacing.

Sensors and Switches > Sensors and Switches - Brakes and Traction Control > Wheel Speed Sensor > Component Information > Service and Repair > Pulse Wheel Drive Shaft, Replacing > Page 2947

[PREV PAGE] [NEXT PAGE]