Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC90 FWD L6-3.2L VIN 98 B6324S (2007)

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Service and Repair > Level Sensor, Fuel Tank, Right-Hand/Fuel Tank, Replacing > Page 3299

Page 4
background image

Remove:

-

the tie strap around the wiring above the pump

-

the level sensor by pressing in the two clips and pulling upwards

-

the thin pipe from the holder on the outside of the fuel tank unit

-

the wiring from the holder in the fuel tank unit.

Applies to vehicles with parking heaters

If the vehicle has an engine block heater, drill out the hole connection in the fuel tank unit. Use a -4 mm drill bit. Transfer the dip pipe.

Installing the right-hand level sensor

Install:

-

the new level sensor

-

the wiring in the holder

-

the thin pipe in the holder on the outside of the fuel tank unit

-

the tie strap around the wiring above the pump

Sensors and Switches > Sensors and Switches - Instrument Panel > Fuel Gauge Sender > Component Information > Service and Repair > Level Sensor, Fuel Tank, Right-Hand/Fuel Tank, Replacing > Page 3299

[PREV PAGE] [NEXT PAGE]