A3 Mk1
| Exploded view IV- adjusting 2nd and 4th gear brake “B2” on gearboxes with shim and retaining ring |
| 1 - | Gearbox housing |
| 2 - | Circlip |
| q | For supporting tube |
| q | Installation position: open ends face retaining wedge of freewheel |
| 3 - | Supporting tube for “B2” |
| q | Insert in such a way that notch engages on wedge of freewheel |
| q | Spare part is allocated according to gearbox code letters |
| 4 - | Outer plate “B2” |
| q | 3 mm thick |
| 5 - | Spring cap |
| q | Fit after installing first outer plate -item 4- |
| 6 - | Spring cap |
| q | Do not install when adjusting “B2” |
| q | Fit before installing last outer plate |
| 7 - | Spring |
| q | Spare part is allocated according to gearbox code letters |
| 8 - | Inner plate “B2” |
| q | Quantity → Chapter |
| q | Spare part is allocated according to gearbox code letters |
| 9 - | Outer plate “B2” |
| q | Quantity → Chapter |
| q | Always install 2 mm thick outer plates |
| 10 - | Outer plate “B2” |
| q | 3 mm thick |
| q | Do not install when adjusting “B2” |
| 11 - | Shim |
| q | Do not install when adjusting “B2” |
| 12 - | Retaining ring |
| q | Is fitted with smooth side on last inner plate -item 8- when adjusting “B2” |
|
|
