ZDX V6-3.7L (2010)
4. Remove the door panel (A) with as little bending as possible to avoid creasing or breaking it.
1. Start at the bottom edge of the door panel, detach the clips (B) with a commercially available trim pad remover.
2. Detach the remaining clips (C).
3. Starting at the rear, pull out the door panel upward.
NOTE: The inner handle cable (D) and the latch cable (E) are connected to the inner handle (F). Do not pull up the door panel too far, or these cables
will be damaged.
5. While holding the door panel away from the door, release the hook (A) and the pin (B) by pulling out the inner handle (C), then remove the inner
handle from the door panel.