ZDX V6-3.7L (2010)
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
If side airbags and/or side curtain airbags have deployed, the affected pillar area trim and attachment clips must be replaced. Refer to Component
Replacement/Inspection After Deployment See: Restraint Systems/Air Bag Systems/Service and Repair.
-
Put on gloves to protect your hands.
-
Take care not to scratch the trim or the panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
The upper clip (A) in the B-pillar upper trim (B) consists of a plastic grommet (C) and a metal pin (D). The grommet expanded by the pin secures
it to the body panel (E). The projections (F) on the pin break during removal, so the upper clip must be replaced with a new one when the trim is
reinstalled.
1. Remove these items:
-
Front door sill trim See: Scuff Plate/Service and Repair
-
Rear door sill trim See: Scuff Plate/Service and Repair
2. Slide the front seat forward fully.
3. Pull back the upper area of the B-pillar lower trim (A) to detach the clips, then release the hooks (B), and remove the trim.