Link/cable connecting handbrake lever to cable - r+r

Operation 3380A38 · Handbrake control and linkage

Removing

Position the vehicle on the ramp.

Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

Proceed with the removal - 3380A10 handbrake lever - r+r.

1. Remove the retainer (1a) and disconnect the handbrake cables (1b).

2. Undo the bolts (2a) and remove the rod/cable connecting the handbrake lever to the cables (2b).

Refitting

Place the rod/cable connecting the handbrake lever to the cable and secure it using the bolts.

Connect the handbrake cables and secure them using the retainer.

Proceed with the refitting - 3380A10 handbrake lever - r+r.

Adjust the travel of the handbrake lever - 3380A04 handbrake - check travel.

Connect the battery terminal (-).

Remove the car from the ramp.