Workshop Manuals Factory service & repair Alfa Romeo
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Alfa Romeo 147 Factory Service Manual (2000-2004)08 · Engine
08 · Engine

Lambda sensor - r.r.

Make
Alfa Romeo
Model
147 Factory Service Manual
Year
2000–2004
Section
Exhaust emission control system › Lambda sensor - r.r.
EngineLambda sensor - r.r.

LAMBDA SENSOR - R.R.

Operation 1080B60 · Exhaust emission control system

1.6 TS · 120 CV

Removing

Position the vehicle on the ramp.

Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

NameConnector
BatteryA1B

1. Disconnect the electrical connection for the Lambda sensor.

NameConnector
1Lambda sensor downstream of post-catalyzerK17
LAMBDA SENSOR - R.R.

1. Release the electrical wiring for the Lambda sensor from the fastenings.

2. Undo and remove the Lambda sensor complete with electrical wiring.

LAMBDA SENSOR - R.R.

Refitting

Place the Lambda sensor back in its housing and tighten it to the recommended torque.

FasteningComponentØ

Value

(daNm)

LAMBDA PROBEM184.1 ÷ 5.0

Secure the electrical wiring for the Lambda sensor to the fastenings.

Connect the electrical connection for the Lambda sensor.

Connect the battery terminal (-).

Remove the car from the ramp.

2.0 TS

Removing

Position the vehicle on the ramp.

Make sure that the ignition key is in the OFF position, then disconnect the negative (-) battery terminal.

NameConnector
BatteryA1B

1. Disconnect the electrical connection for the Lambda sensor.

NameConnector
1Lambda sensor downstream of post-catalyzerK17
LAMBDA SENSOR - R.R.

1. Release the electrical wiring for the Lambda sensor from the fastenings.

2. Undo and remove the Lambda sensor complete with electrical wiring.

LAMBDA SENSOR - R.R.

Refitting

Place the Lambda sensor back in its housing and tighten it to the recommended torque.

FasteningComponentØ

Value

(daNm)

LAMBDA PROBEM184.1 ÷ 5.0

Secure the electrical wiring for the Lambda sensor to the fastenings.

Connect the electrical connection for the Lambda sensor.

Connect the battery terminal (-).

Remove the car from the ramp.

Parts & tools for this job For 2000 Alfa Romeo 147

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.