Steering hard / (steering in both directions)
- Make
- Alfa Romeo
- Model
- 147 Factory Service Manual
- Year
- 2000–2004
- Section
- STEERING – vehicle behaviour › Steering hard / (steering in both directions)
‹ Prev Drift whilst brakingNext › Steering wheel oscillations/ vibrations / with the vehicle stationary
Fault diagnosisSteering hard / (steering in both directions)
STEERING HARD / (STEERING IN BOTH DIRECTIONS)
During normal operation of the steering there is a stiffening of the steering when steering to both the right and the left.
| Results of the tests | ||||
| 0 | PRELIMINARY CHECKS | All OK | Problems met | Operation |
|---|---|---|---|---|
Check that the tyre pressures are correct Check that the power steering fluid level is correct | Continue to Step 1 | Tyre inflation pressure not correct | Restore the correct pressures | |
| Power assisted steering fluid level too low | Restore the correct level: if there are leaks See table X30 | |||
| 1 | CHECK CONDITION OF STEERING GAITERS AND TIE-RODS | All OK | Problems met | Operation |
| Check the condition of the steering gaiters and tie-rods | Continue to Step 2 | Steering tie-rods damaged or worn | Replace the tie-rods Op. 4110B10 | |
| 2 | CHECK TYPE OF FAULT | All OK | Problems met | Operation |
| Carry out a test, turning the steering wheel to full lock under various conditions, checking that there are no faults. | Stiffness continuous and constant | Continue to Step 3 | ||
| Hardness intermittent | Check that the filter inside the reservoir is correctly positioned. if necessary, replace the reservoir Op. 4130B10 | |||
| Hardness only during idling | Check for any restrictions in the pipes (flexible and rigid). If necessary replace the damaged parts, replacing all the seals | |||
| Hardness in end of travel position | Restore the correct wheel geometry | |||
| 3 | STEERING COLUMN BEARINGS CHECK | All OK | Problems met | Operation |
| Check the condition and efficiency of the steering column support bearings, disconnecting the column from the steering box | Continue to Step 4 | Bearings worn or damaged | Restore the efficiency of the steering column. If necessary, replace the bearings involved Op. 4110A31 | |
| 4 | CHECK OPERATION OF STEERING BOX | All OK | Problems met | Operation |
| With the front wheels lifted, make the rack complete its full travel in both directions, making sure that there is no excessive stiffness or play. | Continue to Step 5 | Faulty operation of steering box | Replacing steering box Op. 4130A10 | |
| 5 | POWER ASSISTED STEERING PUMP CHECK | All OK | Problems met | Operation |
| With the wheels on the ground, check the correct operation of the power steering pump | Continue to Step 6 | Belt slack | Check and, if necessary, replace the belt Op. 1092C14 | |
| Power assisted steering pump malfunction | Replace the power assisted steering pump Op. 4130B20 | |||
| 6 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | Fault persists | Search for the fault starting from another symptom' | ||
‹ Prev Drift whilst brakingNext › Steering wheel oscillations/ vibrations / with the vehicle stationary
Parts & tools for this job For 2000 Alfa Romeo 147
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Alfa Romeo power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.