Workshop Manuals Factory service & repair Alfa Romeo
01 General data and specifications02 Engine (Twin Spark, JTD and V6)03 Clutch04 Gearbox (manual, Selespeed and Q-System)05 Front axle06 Brakes, ABS and traction control07 Steering08 Suspension and wheels09 Heating, air conditioning and washers10 Electrical equipment11 Body12 Body panels and reinforcement13 Wiring diagrams14 Connectors and pin-outs15 Wiring harnesses16 Fault diagnosis17 Special tools
Alfa Romeo 156 Factory Service Manual (1997-2002)16 · Fault diagnosis
16 · Diagnostics

X20 Brake fluid leaks

Make
Alfa Romeo
Model
156 Factory Service Manual
Year
1997–2002
Section
Consumption / leaks / wear › X20 Brake fluid leaks
Fault diagnosisX20 Brake fluid leaks

X20 Brake fluid leaks

A brake fluid leak is seen.

StepTest procedureResultAction
0PRELIMINARY CHECKS

Check whether the fault is accompanied by decreased braking efficiency

Visually inspect the brake fluid level in the reservoir Op. 3330A10

OK

Move onto step 1

Decreased braking efficiency

Move onto step (see F01)

Level too low
  • Restore the correct level and carry out a road test. If the defect persists,

Move onto step 1

1RESERVOIR LEAKAGE TEST

Visually check that there are no leaks from the reservoir and the pipes

OK

Move onto step 2

Leaks from the pipes in the area of the reservoir
  • Tighten the pipes (see Assembly 3330C)

End of diagnosis

Leaks from the reservoir

End of diagnosis

2PUMP LEAKAGE TEST

Visually check that there are no leaks of fluid from the brake pump and connectors

OK

Move onto step 3

Leaks from the connectors in the area of the pump / ABS control unit
  • Tighten the connectors or replace the damaged parts (see Assembly 3340B)

End of diagnosis

Leaks from the pump

End of diagnosis

3CHECK HOSES

Visually inspect that there are no leaks from the hoses

OK

Move onto step 4

Leaks from the connectors or hoses deteriorated
  • Tighten the connectors or replace the hoses involved (see Assembly 3340B)

End of diagnosis

4RIGID PIPES CHECK

Visually inspect that there are no leaks from the underbody rigid pipes

OK

Move onto step 5

Leaks from the connectors or rigid pipes damaged
  • Tighten the connectors or replace the rigid pipes (see Assembly 3340B)

End of diagnosis

5CHECK CORRECT OPERATION

Check that the fault is no longer present

OK

End of diagnosis

Fault persists

Incorrect selection of diagnostic procedure

Parts & tools for this job For 1997 Alfa Romeo 156

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.