Removing and installing splash plate

Make

Audi

Model

A1

Section

Brake, brake mechanics › Rear brakes › Removing and installing splash plate

Running gearRemoving and installing splash plate

Removing and installing splash plate Removing –  Raise the vehicle. –  Remove wheels. –  Remove brake disc → Chapter.

–  Unscrew bolts -3- securing splash plate. –  Detach splash plate -4-. Installing Use new bolts. –  Clean splash plate and wheel hub.

–  Fit splash plate -4-. –  Fit bolts -3- and tighten. –  Install brake disc → Chapter. –  Fit wheels → ELSA/ Wheels and Tyres Guide → Rep. gr.44. –  Lower vehicle. –  Check brake fluid level and top up if necessary.   Note After installation, firmly depress the brake pedal several times with the vehicle stationary so that the brake pads are properly seated in their normal operating position.   Caution Make sure that the brakes work properly before the vehicle is driven on the road.

01 Steering & suspension