Removing and installing roof aerial

Make

Audi

Model

A1

Section

Infotainment › Aerial system › Removing and installing roof aerial

Vehicle electricsRemoving and installing roof aerial

Removing and installing roof aerial The roof aerial -R216- has one connection. The aerial wire is plugged in at the roof cross member (left-side). To remove roof aerial -R216-, lower headliner at rear. –  Switch off ignition and all electrical equipment and remove ignition key. Removing –  Lower moulded headliner at rear → General body repairs, interior; Rep. gr.70.

–  Release and unplug connector -2- for aerial wire. –  Unscrew nut -1-. –  Lift roof aerial -R216--3- off roof. Installing –  Guide in aerial wire through roof opening and carefully fit roof aerial -R216- onto roof. –  Ensure that seal is seated properly. –  Install in reverse sequence of removal. Tightening torques → Chapter

05 General