SRX AWD V6-3.6L (2008)
23. Remove the foam seals from the A/C evaporator lines.
24. Remove the foam seals from the heater core pipes.
Installation Procedure
1. Install new foam seals onto the heater core pipes.
2. Install new foam seals onto the A/C evaporator lines.
3. Install the HVAC module into the vehicle.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
4. Install the upper left HVAC module mounting nut (1).
Tighten the nut to 9 N.m (80 lb in).
