(1242) 16v

(1242) 16v

1. Disconnect the air pipe from the filter casing to the throttle casing, complete with resonator, after having loosened the bands. 2. Disconnect the electrical connection for the throttle actuator, undo the fixing bolts and detach the throttle casing. - at the end of the refitting operation, carry out the throttle valve angular position learning procedure as described in the appropriate paragraph.

MOTORIZED THROTTLE VALVE ANGULAR POSITION LEARNING PROCEDURE. Procedure with diagnostic equipment - Connect the diagnostic equipment (Examiner or Examiner Plus) to the standardized socket and turn the ignition switch to the ON position (engine off). - Wait during the throttle casing check until the diagnostic equipment confirms the positive result of the learning procedure. - Turn the ignition switch OFF and check that the diagnostic equipment signals the end of the procedure. Manual procedure - Turn the ignition switch to the ON position (engine off). - Wait for 45 seconds (the time whilst the control unit carries out the learning procedure). - Turn the ignition key to the OFF position. TIMING SENSOR Removing-refitting - Disconnect the negative battery terminal. - Detach the engine sound insulation

3. Disconnect the electrical connection, undo the fixing bolt and detach the timing sensor.