Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Refitting

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Fuel feed system (2000 range, 1242 16v) › Refitting
10 EngineRefitting
Diagram showing a spanner being used to detach the Lambda sensor, with inset detail of the tool and removal/installation arrows.
  1. Using a USAG 875 type spanner or similar tool, detach the Lambda sensor.

REFITTING

  • Position the sensor and tighten it to torque avoiding exerting force on the component in order not to damage it irreparably. Apply graphite grease to the sensor thread (e.g. Bosch 5 964080112).
  • Connect the connector and restore the fastenings for the Lambda sensor cable.
Diagram showing the rear Lambda sensor location with wiring and retaining bands, and removal/installation arrows.

REAR LAMBDA SENSOR

Removal.

  • Position the vehicle on a lift.
  • Disconnect the negative battery terminal.
  1. Disconnect the electrical connection for the rear Lambda snsor and release the wiring from the retaining bands.
Diagram showing a spanner being used to detach the rear Lambda sensor from the exhaust manifold.
  1. Raise the vehicle and detach the Lambda sensor.

REFITTING

  • Position the sensor and tighten it to torque avoiding exerting force on the component in order not to damage it irreparably. Apply graphite grease to the sensor thread (e.g. Bosch 5 964080112).
  • Connect the connector and restore the fastenings for the Lambda sensor cable.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.