Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Accelerator cable removal

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Fuel system (99 range) › Accelerator cable removal
10 EngineAccelerator cable removal

Accelerator cable removal

Diagram showing the location of a stud on the bulkhead between the engine bay and passenger compartment, with arrows indicating movement.
Diagram showing the bolt retaining the accelerator cable ducting device on the bulkhead and the underlying rubber block.
Diagram showing the accelerator cable being released from a retaining clip located beneath the injection control unit.
The removed accelerator cable shown as a separate component.
  1. Remove the stud shown in the figure and move the lining of the bulkhead between engine bay and passenger compartment to one side.
  2. Unscrew the bolt retaining the accelerator cable ducting device, on the bulkhead between engine bay and passenger compartment. Also remove the underlying rubber block in order to free the hole and allow removal of the cable.
  3. Release the accelerator cable from the retaining clip located beneath the injection control unit.
  4. Withdraw the cable through the hole in the bulkhead between engine bay and passenger compartment and remove from the engine bay.

When refitting, adjust the cable as described in the paragraph "Adjusting throttle cable" in Section 10 "Fuel system" for the left hand drive version.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.