Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Removing-refitting accelerator pedal

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Fuel system (99 range) › Removing-refitting accelerator pedal
10 EngineRemoving-refitting accelerator pedal
Diagram showing the throttle valve lever and accelerator cable connection in the engine bay
Diagram showing the left foot rest and its retaining bolts on the accelerator pedal assembly
Diagram showing the control cable anchorage point on the accelerator pedal from inside the car

REMOVING-REFITTING ACCELERATOR PEDAL

Disconnect the battery negative terminal, then proceed as follows:

  1. In the engine bay, turn the throttle valve lever and release the accelerator cable. Remove the clip and withdraw the cable from the bracket. This operation is necessary to facilitate removal of the accelator cable from the control pedal.
  2. Working from inside the car, remove the left foot rest by undoing the retaining bolts shown in the figure.
  3. Disconnect the control cable from the anchorage on the accelerator pedal.
  4. Disconnect the clutch pedal reaction spring (attached to the accelerator pedal bracket) by removing the roll pin indicated.
Diagram showing the clutch pedal reaction spring and roll pin attachment on the accelerator pedal bracket

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.