Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Removing-refitting accelerator cable

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Fuel system (99 range) › Removing-refitting accelerator cable
10 EngineRemoving-refitting accelerator cable · page 1 of 2
Diagram showing the upper cam cover with retaining screws and a FIAT logo on the cover
Diagram of the engine bay showing the accelerator cable, retaining clip (1) and nut (2)

REMOVING-REFITTING ACCELERATOR CABLE

Disconnect the battery negative terminal, then proceed as follows:

  1. Remove the upper cam cover protection.
  2. In the engine bay, release the accelerator cable by taking out retaining clip (1) and unscrewing nut (2).
  3. Working from inside the car, remove the left foot rest and unscrew the bracket retaining the air hose shown. Disconnect the pipe from below to allow access to the cable anchorage on the accelerator pedal.
  4. Disconnect the control cable from its anchorage on the accelerator pedal.
Diagram showing the left foot rest area with arrows indicating removal points and the accelerator pedal assembly
Diagram showing the accelerator pedal and control cable anchorage point under the dashboard

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.