Refitting (page 2 of 2)

The following conditions must be satisfied in order to ensure polymerisation occurs:

• keep the gasket sealed in its plastic bag;
• take out only shortly before fitting;
• do not oil the gasket or contaminate with oil. Ensure cylinder head and crankcase surfaces are thoroughly clean.

1. 2. Then fit the cylinder head and tighten retaining screws to a torque of 2 daNm. Observe the tightening pattern shown in the figure and use too. 1852157000. Then tighten bolts to a torque of 4 daNm, following the same pattern.
2. Use wrench 1852157000 with angle wrench 1895897000 to tighten cylinder head bolts through a further angle of 180° in two different stages(90°+ 90°), following the same tightening pattern.
3. Fit cylinder head extensions and tighten bolts to specified torque.

Refit parts removed previously by reversing disassembly instructions. Fit timing and auxiliary belts and tension as described in the previous paragraphs.