Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)02 · 10 Engine
02 · Engine

Fitting cylinder head (page 2 of 2)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting cylinder head (1929 D)
10 EngineFitting cylinder head · page 2 of 2
Diagram showing the tightening sequence for cylinder head bolts, numbered 1 through 10.
Diagram illustrating the angular tightening of cylinder head bolts, marked with a 90° angle.
Diagram illustrating further angular tightening of cylinder head bolts, marked with a 90° angle and an alpha symbol.
Diagram showing the tightening of outer cylinder head bolts using a torque wrench.
1. Tighten cylinder head bolts as follows. Note that tightening order is as described for each tightening stage: - lubricate bolts and washers with engine oil and leave to drain for at least 20 minutes; stage 1: tighten bolts to a torque of 5 daNm; stage 2: tighten to a torque of 10 daNm using a torque wrench. 2-3. Angular tightening of cylinder head retaining bolts: stage 3: tighten bolts through 90°, following the specified order. stage 4: tighten bolts through a further 90°, still following the specified order. 4. Tighten outer bolts to a torque of 3 daNm to complete cylinder head tightening. NOTE Reverse removal instructions in order to refit other cylinder head parts.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.