Removing-refitting (page 2 of 4)

1. Position the power unit support stand 1860851000 and the special adaptor 1860851001 in the appropriate mounting points. a. Front mounting: insert the tool in the seating of the bonnet catch, so that it rests on the front crossframe. b. Rear mounting: position the tool level to the central reinforcement of the fire-proof bulkhead. c. Secure the hook of the stand to the eyelet previously installed level with the exhaust manifold attachments.

2. Relieve the staking and then remove the hub nut (gearbox side and timing gear side).