Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)04 · 21 Gearbox and differential
04 · Transmission

Removing-refitting (page 3 of 4)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Removing-refitting (1929 D)
21 Gearbox and differentialRemoving-refitting · page 3 of 4
Diagram showing the plastic protection on the wheelarch on the gearbox side with bolts and a button indicated.
Two diagrams: top shows a tie-rod end connection, bottom shows a puller tool (1847038000) being used to separate the tie-rod end from the vertical link arm.
Diagram showing bolts securing the vertical link to the damper.

  1. Remove the plastic protection from the wheelarch on the gearbox side by undoing the bolts and the button shown in the figure. To withdraw the protection, also disconnect the brake pad wear sensor connection (repeat the procedure on the other side).
  2. Remove the nut securing the tie-rod end to the vertical link, then withdraw the tie-rod end from the vertical link arm using puller 1847038000 (repeat the procedure for the other tie-rod end).
  3. Remove the bolts securing the vertical link (gearbox side and timing gear side) to the damper.
  4. Rotate the vertical link as appropriate to withdraw the drive shaft from the wheel hub (repeat the procedure for the other drive shaft).
Diagram showing the drive shaft being withdrawn from the wheel hub area after the vertical link has been rotated.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.