Refitting

Refitting

Refit the selector lever position sensor as follows:

1. position the sensor, tighten the central nut and lock it with the washer;
2. from position P (fully rotated in a clockwise direction) move the pin of the lever to position N (rotating the pin two notches in an anti-clockwise direction);
3. rotate the sensor so that the projection on the top surface (1) lines up with the side machining on the pin (2), then lock the sensor in this position by tightening the two side screws.

It is advisable to position the sensor using an ohmmeter connected between terminals 6 and 10 of the supply connector. Rotate the sensor to the centre of the area in which the ohmmeter detects continuity (contacts N and P closed), then tighten the sensor screws.