Removing

Removing

Remove the air intake duct, battery, relay and fuse box (move it to one side) the i.e. control unit and battery cage, as described for the removal of the gear change cable, position the selector lever at P, then carry out the following operations:

1. Disconnect the wiring connector from the gear change lever position sensor.
2. Remove the split pin and washer so as to disconnect the gear change cable from the lever on the sensor.
3. Undo the nut securing the lever to the sensor, then remove the lever.
4. Release the central nut from the washer and remove the nut, then undo the two side bolts securing the sensor and remove the sensor.