Gear change cable

Also check the condition of the oil, and in particular that there is no white contamination caused by contact with the coolant from the oil cooling circuit, and that there are no metal particles due to wear of internal components or a burnt smell.

WARNINGS
– If the oil level is low, there may be a reduction in the line pressure owing to the fact that the oil pump draws in air, resulting in malfunctioning of the transmission.
– If the oil level is higher than normal, there may be oil leaks from the vent pipe.
– Contamination of the oil with water or the use of an oil with different characteristics from the recommended oil causes higher consumption and malfunction of the transmission.

GEAR CHANGE CABLE

Removing

Disconnect the battery's negative cable, then proceed as described below:

1. Remove the air intake duct by undoing the bolts shown in the figure, which secure it to the front cross panel.
2. Lift the cover protecting the battery positive pole and disconnect the cable; undo the nut securing the battery to the cage, then remove the battery from the engine compartment.
3. Remove the cover from the relay and fuse box by undoing the screw indicated.