Gear change cable (page 2 of 5)

Make

Fiat

Model

Bravo /Brava (182) Factory Service Manual

Year

1995–2001

Section

Servicing and adjustments (Automatic)

21 Gearbox and differentialGear change cable · page 2 of 5

1. Remove the nuts securing the relay and fuse box to the battery cage, then move the box over to one side.
2. Disconnect the i.e. control unit supply connector.
3. Disconnect the earth cable (1), remove the nuts securing the i.e. control unit mounting bracket, then remove the control unit from the engine compartment. The nuts indicated also secure the starter motor supply wiring and the front cable/fuel injection cable connection.
4. Remove the bolts (1) and slacken the bolt (2) securing the battery cage to the body shell. Before removing the cage, disconnect the cable clip underneath.
5. Remove the split pin and washer shown in the figure; lift the gear change cable head so as to disconnect it from the gear change lever position sensor.

04 Transmission